It is known that the temperature of the soldering iron depends largely on the quality of the performed installation. Are particularly bad (if not harmful) to overheat. Immediately deteriorating the quality of the soldering, there is a risk of peeling the printed wire Board, is accelerated wear of the operating rod, and even failure of the heating element. Sting often cleaned of oxides and overheated — not holding solder.
GARBAGE SEPARATELY AND PETROL SEPARATELY
Looking at the picture, the reader will notice that the use of plastic bottles as funnels. But the funnel offer may be a good filter, capable to protect the fuel system of your vehicle from debris. It’s enough to cut with a knife a hole in the lid, pull at the neck of the bottle Read more…
For feeding low-voltage soldering iron from a household outlet uses simple adapters, which are, as a rule, the quenching capacitance (capacitor for a specific value). However, the use of such a device for installation of equipment with microprocessors, field-effect transistors and other electronic components afraid of static electricity is undesirable. Too high risk of breakdown due to the direct connection of the heating element with electricity of high voltage. Need galvanic isolation. For example, in the form of a step-down transformer.
