It is known that the temperature of the soldering iron depends largely on the quality of the performed installation. Are particularly bad (if not harmful) to overheat. Immediately deteriorating the quality of the soldering, there is a risk of peeling the printed wire Board, is accelerated wear of the operating rod, and even failure of the heating element. Sting often cleaned of oxides and overheated — not holding solder.
IN THE ARMS OF THE CLAMP
When driving round a pin in the prepared hole in the particle Board there is a danger that tightly the incoming rod will break loose material. To avoid this, pre-shrink this place a C-clamp — spike will not damage the stove, even if it will have to be a hammer.
For feeding low-voltage soldering iron from a household outlet uses simple adapters, which are, as a rule, the quenching capacitance (capacitor for a specific value). However, the use of such a device for installation of equipment with microprocessors, field-effect transistors and other electronic components afraid of static electricity is undesirable. Too high risk of breakdown due to the direct connection of the heating element with electricity of high voltage. Need galvanic isolation. For example, in the form of a step-down transformer.
