Advice

In the manufacture of furniture with the use of plug-in round thorns is very important equally to mark the holes for them on both abutting parts. A simple jig can turn… pushpin. They are easy to attach with glue or small nails on the wooden rail so that they were at a certain distance from Read more…

If the Ironing Board has the opportunity to carve out a space in a permanent place, and it is not necessary each time to add and remove — install bottom boards socket: it will be convenient to connect the iron, and the cord will not, normally, interfere with iron. It’s worth doing and folding the Read more…

In the manufacture of structures made of pipes of the same diameter to neverlet holes in them easily and quickly will help here’s a simple jig. It consists of a metal plate and wooden block in advance which is made a longitudinal cut. In the bar there are several vertical through-holes for drill bits of Read more…

Every driver or owner of the motorcycle with two-cylinder engine can turn the vehicle in… the compressor. It is only necessary to produce the simplest device, shown in the figure. It consists of the spark plugs and fitting (4) from ball valve (3) from manual automotive pump. To connect the fitting with the housing of Read more…

In modern household appliances, sanitary wares found a lot of threaded connection parts with hexagon sockets for the key. If necessary to disassemble a node with such parts is not at any DIY tool in the Arsenal of the right hexagon. But the bolt and the corresponding socket and a pair of nuts to it Read more…

Experienced motorists have long noticed that the cans often “hidatsa” at the bottom corners. To extend the life of canisters, it is recommended to tie the box by rubber bands cut, for example, old car cameras.

Cast in many industrial products have long been used mortgages (anchor) bolts with special heads, such that not only pull, but rotate can’t. With the advent of high strength composite self-hardening compositions that bolt you can “lay” in the body of the finished product (plastic or metal) and making it pre-nest, and then simonaityte.

Sometimes the connection details homemade design does not need the usual hex nuts and the so-called wing (with ears). The advantage of the latter is that to tighten and Unscrew them by hand. But such is not always available, and in selling, they should still find. Meanwhile, to make the nut that will serve the Read more…

Real baked, as at the stake, the potatoes you can get at home. Need to fill in a deep pan of sand or salt, from above to lay the tubers and cover with a lid and inverted the old pot, set it all up on a gas stove. The result will exceed all expectations, the Read more…