Advice

Experienced motorists have long noticed that the cans often “hidatsa” at the bottom corners. To extend the life of canisters, it is recommended to tie the box by rubber bands cut, for example, old car cameras.

Cast in many industrial products have long been used mortgages (anchor) bolts with special heads, such that not only pull, but rotate can’t. With the advent of high strength composite self-hardening compositions that bolt you can “lay” in the body of the finished product (plastic or metal) and making it pre-nest, and then simonaityte.

Sometimes the connection details homemade design does not need the usual hex nuts and the so-called wing (with ears). The advantage of the latter is that to tighten and Unscrew them by hand. But such is not always available, and in selling, they should still find. Meanwhile, to make the nut that will serve the Read more…

Real baked, as at the stake, the potatoes you can get at home. Need to fill in a deep pan of sand or salt, from above to lay the tubers and cover with a lid and inverted the old pot, set it all up on a gas stove. The result will exceed all expectations, the Read more…

Draw with your compass a circle is not a problem, at least with a pencil, though ink. For this purpose, as is known, there is his replacement leg. If instead the stylus or raspadura to insert it into the reusable part of the blades design knife — get a handy torch for arc or circular Read more…

The main advantage of the Phillips screwdriver slotted in front of the centering tool and fastener, in which virtually eliminates the slipping of the sting with head even with a small misalignment of the tool. Almost the same effect can be achieved slotted screwdriver if the to change its tip as shown in the figure Read more…

It is often necessary to cut a wooden rod so that you get two identical halves – for example, for the manufacture of frames for drawings or photos. However, the one who tried to do it knows that the saw will cut and leave aside. This will not happen if to use here such a Read more…

Ordinary entrenching tools – shovels, rake-wood handle is not very comfortable: it is difficult to hold during the swing or swivel movements. Can be easily done using existing old tool here’s a loop of a handle, like industrial design. It is made of cut metal pipe, cut as shown in the figure. After removal of Read more…

Always hard to find in a drawer or box required a small detail, especially if they are stored in what is called bulk. However, quite on the workshop wall to attach here a stand and not have to dig and waste time looking for the right small things. The fact that the stand is made Read more…