Advice

To lift and move manually to a large barrel and it is not easy and inconvenient: not to hold on. Meanwhile, equip it with a pair of convenient handles very easy. Do in the side wall at the upper edge are two semi-circular cut. Fold the resulting segments up and put a bend section thick Read more…

The glass cutters with carbide rollers are widely used by home craftsmen. But those who work with glass often still prefer the diamond. And it’s not just more sharpness and hardness of tool: carbide have a slight drawback — the increased axial play of the rollers. To correct this defect a few minutes. Disassemble the Read more…

To protect the cutting edges of tools from accidental damage during storage and transportation will help simple cozies. They can produce in just a few seconds. Take a cut from leather, thick cloth or canvas strip, fold it in half to connect the sides with scriptorially.

The production of almost any wood product begins with the receipt of smoothly planed boards. And for quality it is important that their plane was not only smooth, but also are mutually perpendicular. However, the usual plane of the latter to achieve is not so simple. If the Board is narrow, and the wood is Read more…

A lot of any tips on winterizing the Windows in the winter. I decide all problems, zakieva them to the linen strips, soaked in soapy water. Such strips after soaping become impermeable to air, a well-glued and easy to remove, no pulling a layer of peeling paint. Yes, and you can serve without replacement for Read more…

The design of this device and receive the dissolution of the long boards alone I suggested to an experienced cabinetmaker. Before you cut from boards (chipboard, plywood) equity bar, it is necessary to first make a simple device: a couple of small wedges to connect a thin nail with a gap between them equal to Read more…

The stump on the dacha is usually not only a hindrance but also a problem: to root out its not so easy. However, you can not get rid of it, but rather made to serve. For example, using it as a base, attach it to the original table. This wooden bars directly mounted on a Read more…

Convenient aerosol package, but ends with the contents of the canister and it has to be thrown away. But could he do a new application? I decided to make out of empty spray paint roller. For this I drilled the bottom center hole Ø 4.2 mm, the same was done from the top, where before Read more…

This simple improvement will facilitate the work standard screwdriver, especially where it is difficult to get the tip into the slot of the screw or screws. This will require only two items: a small spiral spring, is wound directly on the rod of the screwdriver, and cut a metal tube. Its inner diameter should correspond Read more…