The fixture is designed without a preliminary marking to make notches in the hubs of the propeller blades.CUTS WITHOUT MARKING
The fixture is designed without a preliminary marking to make notches in the hubs of the propeller blades.
The fixture is designed without a preliminary marking to make notches in the hubs of the propeller blades.The tightening of a screw into a solid material gives a lot of trouble. Enough only slightly to tilt the screwdriver as that breaks down, sometimes cutting slot of the screw. To avoid this trouble will allow the following advice. Sharpen a screwdriver with a semicircular file or emery wheel — as shown in the Read more…
is Drawn through the funnel and bound in a ring of nylon cord provide drainage when filling the vessel with liquid. Simultaneously, the loop will serve as a handle for hanging.
When welding T-joints of pipes pre-combining them is difficult. Made a fixture consisting of two metal plates, studs, and two nuts, it is possible to securely lock the segments of pipe in the desired position.
Pliers and carpal expander, which is sold in any store “Sports” is all that is necessary for making the simplest grip. A. KOTLOVSKY, Boguchansk, Krasnoyarsk Krai
To books on the shelf stood upright, their back so those are the footings of two scrap boards connected at a right angle, and a reinforcing cross member. However, on the polished surface of the stand is bowing under the weight of books can slide. This will not happen if both its external surface to Read more…
Get a new apartment, faced with such unpleasant phenomena as a creak of door hinges. Tried, removing the doors and hinges lubricated to eliminate the defect, but there it was. It turned out that the grooves for them are made hastily, with bias. I palapeli top of each drilled hole Ø 3 mm away from Read more…
Every year increases the number of syt and Palaces of pioneers, where the pipeline automodelismo. During the construction of trails is often necessary to perform smooth transitions from concentric circles to parallel straight, which causes some difficulties. At the station of young technicians of the Leningrad district of the city of Yerevan was built trendoriginal track. Today we decided to share our experience of graphical representation of the curves of the track.
In the journal “modelist-Konstruktor” No. 3 for 2006 C. A. Kotov shared with the readers the experience in the manufacture in a home workshop metal using scrap materials, in particular, one of his options was made on the basis of the hockey stick. Developing this theme, the author offers a new development.