Offer your variant of the design of the armchairs, on the basis of which you can make a new seat or redo is available. In my order was old, from a set of upholstered furniture “Narspi”. Alteration it was. The seat of a chair (Fig.1) at an angle — I had to make it horizontal. Below him to both sides of the seat put two strips 4 which serve as guides for the sliding part of the lounger. To increase the stiffness of the main structure side of the chair connected crossbar 2 and the rear panel 5 (used the existing chair). Connection — with the help of furniture parts and screws. Retractable parts are collected separately.
CHAIR BED
Good day dear reader.
This versatile stool which if necessary can turn into a small stable ladder, absolutely necessary in those apartments where there are high cabinets and mezzanines.
A good housewife does not throw out the sprouted onions, and carefully seated them in appropriate jars with water. In the end, after a week or two on the table at the family appear juicy vitamin “arrows”.
Durable, reliable, sustainable, it gives the impression of a powerfully built all-in-one monolith. But it is worth a little bit more pressure towards each other the upper cross member of the seat side — as the chair will pliable to take shape, turning into a flat package. And if reverse pressure is routed again to a certain point, forming a rigid structure, like all its parts are firmly knitted together by nails.
When construction troubles in the suburban area behind, and finally, there is not just a roof over my head, and housing, regardless of how large or small, there is another problem — the improvement that is built.