The model is ready, applied the last layer of putty. It is time to begin painting. Soon the model will become strict and graceful look, will emerge more noticeable the line of lines, curves, a glossy surface will fall light patches. You can understand the impatience of the young designer when there is so little to the first test of the new device. And now look what happened… Ran, although not very clearly, traces of brushwork, striking streaks of paint and blotched, uneven border colors.
Read more
To have Pets in the farm economy, of course, fine, but try to feed them! For many of them forage vegetables — pumpkin, beets, and other succulent forage — you have to shred on a grater. In the end I tired of every day for one to two hours to do such unproductive work, and I made electrothermo. Just three or four minutes she grinds is so much food that its enough for two adult pigs.
In December 1941, the design Bureau of Chelyabinsk Kirov factory (up to October 1941 – Chelyabinsk tractor plant) representatives of the Armored Directorate of the red Army considered the draft design of the new tank “Klim Voroshilov” – KV-13 — “high-speed tank enhanced reservation”. According to the designers, it’s time to create a “single tank”, who would be able to combine all the positive characteristics of serial KV and T-34. The fact that KV was very difficult to manufacture, “not enough technologically advanced and not suitable to mass production in wartime”. They had surpassed the T-34 but more powerful armor.
What are the only propellers is not built by modelers. Due attention was paid to the three blade. Why not try to install them on a modern cord “acrobat”? If Yes, will any benefit from the extra blades? Elaborate design, drew and made templates. Finally cleaned the sawdust out of the room evaporated the smell of varnish. The case for breakdown in air.
The tillers were made by my father Allan Slavicek mäki in 1984 and is intended for the cultivation and processing of heavy soils. Engine. – scooter VP-150: single cylinder carbureted 2-stroke, forced air cooling. But was later replaced by a more powerful scooter “Tula 200”. Now how easily even the plowing of virgin land. The ignition system is converted into a magneto for tractor starting engines “PD-10M”, it was taken and vostokfilm.
The project is called “IRBIS”, which means snow leopard generated for serial release professional 3-D complex. The complex includes a 3-D printer high resolution and large print area. Automatic 3-D scanner for high-resolution rotary table and the extruder for the production of ABS rod for printing with a diameter of 3 mm.
You built a sailing ship — yacht, Dinghy, catamaran, or simply equipped with a kayak sail. There is no doubt that the main attention was paid to the fabrication of the hull, mast and sails. On a small, inconspicuous at first glance the parts of a sailboat, remember, in the best case, upon completion of its construction or even after the boat in the water and the first trial of sailing. But these details nonetheless are an inseparable part of the vessel.
