The model is ready, applied the last layer of putty. It is time to begin painting. Soon the model will become strict and graceful look, will emerge more noticeable the line of lines, curves, a glossy surface will fall light patches. You can understand the impatience of the young designer when there is so little to the first test of the new device. And now look what happened… Ran, although not very clearly, traces of brushwork, striking streaks of paint and blotched, uneven border colors.
HERE’S A SPATULA
We are all accustomed to the fact that the spatulas (tools for applying putty) are smooth metal, plywood or rubber plate. Of course, if you want luted to a flat surface, they can not do without. But in many cases, a flat surface (in particular this applies to the walls) but does decorate the interior. Read more…
DOUBLE-BUTTON
The belt on the buttons unbuttoned even faster than secures, even from mild random efforts. However, to abandon the buttons and replace them with, for example, hooks is not necessary. A small improvement — and is amazing: here is a duplicate keypad lock, which is shown in the figure, unexpectedly will never undo. He arranged Read more…
WASHER — SCREWDRIVER?
If not at hand will be a screwdriver, do not worry: the bolt, two nuts and a washer of suitable thickness in many cases with success will help you to wrap or remove the screw or bolt.
BARRIER WHEEL – NOT AN OBSTACLE!
Maybe someone will seem ridiculous the claim that wheel the machine can fly over the fence, but not young technicians from the laboratory of experimental modeling and design Cute Novosibirsk Akademgorodok. On the contrary, they talk seriously about the ability of the wheels to overcome ledges, ditches, steep slopes… And in support of their arguments build working models of all-terrain vehicles. One of them is remotely controlled amphibious Atlant — created by young designers Cut Lipenkov Andrey and Dima Yakovlev.
PIN-PULLER
Once worked with manuscripts in the shade of a leafy tree. Suddenly, one of the paper sheets picked up by the wind and lifted up quite high, where he was stuck among the branches. Even from the ladder before him could not reach. The memory came an old hint (sorry, I do not remember where Read more…
HOLDER WITH EYELET
Tighten the screw in a tight place you would help an ordinary wire with a eyelet on the end, bent as shown in the figure.
LEARN TO FLY!
You built the plane. Naturally the desire of the designer to quickly rise into the air. However, the first thing you must “train” to learn flying on your aircraft are extremely serious and responsible. First of all it’s elaborate and it is good to understand the fundamental principles of flight dynamics, principles of stability and controllability of the aircraft. You need to assess what dynamic features are common to your machine – in particular, what is the stall speed, takeoff and landing and maximum speed, how effective are the rudders, and finally, how stable in the air the unit itself. And only then can you begin the exercises in the cockpit and actually fly, strictly following the principles of gradualism in the development of the machine. Today we open a kind of correspondence summer school for Amateur constructors and pilots. We will introduce you to the basics of flight art the most common mistakes novice pilots, as well as techniques correct behaviour of pilots in extreme situations.
TAPE FOR WING
Is a beginner model airplanes at least once to see the competition of the dogfight, as he immediately declares: “I Want to build bouzouki!” And it can be understood: indeed, the air battle — an exciting spectacle, besides themselves “fighters” is so simple that just a few days the athlete, who undertook a new car, already feeling it in the air. And then you can dispense with the use of scarce balsa. And unlike other classes in a dogfight is often possible to achieve good results even with accelerated serial domestic engine.TO HELP THE CABINETMAKER
What tools not in the Arsenal home master furniture maker. Offer another one. It can help you to choose the decorative grooves on the exterior panels. For the manufacture of this device, you will need two bars of hard wood, a piece of saw blade and two screws with nuts.










