BETWEEN THE CEILING AND FLOOR

BETWEEN THE CEILING AND THE FLOOREvery thing in the house requires a certain space. Updated your library, does kolichestvo aquariums — in any case before you arises the problem of their placement. To solve this problem will help steplag simple design. For its production you will need six water pipes and five or six boards (sheets of plywood or particle Board) with a minimum thickness of 20 mm. the Exact length of pipe and the dimensions of the shelves to stipulate does not make sense, because in each case their sizes will be determined by the height of the ceiling, the appointment of the rack, the size intended for his area.

Read more

THE ANTENNA… HIGH-SPEED MANUFACTURING

ANTENNA... RAPID MANUFACTURINGOnce, while on vacation with an overnight stay in a tent on a wooded Bank of the river, found an annoyance: a portable TV operating off the car battery, bad was shown on the set of the antenna due to the weakness of the incoming signal. Then began experiments with aerial: spinning her this way and that, but to no avail. Then began to try to connect to the antenna and instead found in the boot of the wire. He was placed in different places, all sorts of curved loops, but otoh, too, almost gave nothing – UHF signal with a piece of wire was seen as bad.

Read more

“…TO UNWIND THE YARN,”

Fingering binder “Modeller-designer”, I found in No. 11 for the year 1978 note “Fixture austere”. It was about the simplest device which can be used to facilitate the rewinding of the yarn from the skein into a ball. When he is not faced with this problem, the case seems simple, but it so happened that my wife was “dismissed” woolen dress. Rewind the wool from the ball into skeins, washing… But when we tried again to form from yarn tangles, I had to invent a device for this because hair tangled and matted during washing and just coil it slipped from the bottles following the thread.

Read more

THE ELECTRICAL TERMINAL IS A FORMER TUBE

ELECTRICAL TERMINAL IS A FORMER TUBEIn Amateur practice it sometimes becomes necessary to connect to the layout of the electronic device or the measuring device of the connecting wires. Most convenient to do this using terminal, but under their hand often does not happen. Meanwhile, quite a handy terminal can be easily and quickly — just over a quarter of an hour to make usual tubes (toothpaste or cream).

Read more

BY THE WAY ABOUT THE EPOXY

BY THE WAY ABOUT THE EPOXYThere was a time when a cracked handle of radio, split arm shift lever of the car has forced me to look for a replacement in the stores, and, frankly, often unsuccessfully. I tried to carve them out of various plastics or metal, but this was laborious and time consuming. In addition, not always possible to bring the home up to full compliance with the lost original.

Read more

MIXER FOR A MINUTE

From the thoroughness of mixing epoxy resin with hardener and plasticizer depends largely on the quality of veclachi. If mix components in the traditional way with a wooden stick — then the operation will have to spend at least 15 min. Much faster things will go if you take our advice. Two-three-millimeter wire lignite simple Read more…

THE SUN IN HARNESS

The intricate design shown in the picture, — not that other, as the solar engine, the engine that converts the thermal energy of sunlight directly into mechanical work. It is arranged simply. The surface of the octagonal drum represent the bimetal plate. With the middle of each bound metal rod heavy enough counterweight. Opposite one Read more…

POTICA AND BROACH

Deformed copper or brass wire you can make a perfectly smooth and straight in just a minute. Board hammer in a few nails to pass through them the wire, as shown in the figure and stretch it, storing the coil or drum. Wire, covered with insulating enamel, stretching in this way is not recommended — Read more…