Advice

Garden wheelbarrow will last much longer if stands are to be equipped with additional rubber feet, taken from the old buildings of the radios.

On my tape deck broke the teeth of podcatching. Tried to replace the whole unit, but . to no avail. Had to find a way out. Broke off three teeth from metal combs heated over the flame and, holding with tweezers, melt is broken. Appearance is not deteriorated, and podcatching reliably serves more than three Read more…

It happens that the edge of the sheet material must be fixed with nails. But to use a conventional hammer, as this can damage the surface. Come to the aid of an ordinary clamp. She presses the nail as the pushpin.

Works as a blacksmith, I want to tell you a secret: it’s easy to Unscrew the rusted screw connections. Since they have the opportunity — heat the screw a few degrees to about 500-600 (roughly when the metal a little blush). Then dipped in water and hold until cool. While you hear crackles, especially major Read more…

The cartridges for refilling gas lighters very durable case, it is a pity to throw away. Tried to find them a different application. The most successful, I think, is to make handles for tools From the empty casing cut bottom and from the back side gently shake the valve. Now insert the wooden cylinder inside Read more…

To remove or hang on the door hinges alone — for many, this becomes an intractable problem. Make the device shown in the figure, and the case will move forward.

Every motorist at least once found themselves in difficult situations, losing the car keys. Well, if it is detected at house and you can escape for a duplicate; otherwise you have to resort to suspicious methods. But the solution is simple. You’ll need plastic bag the magnet and the paperclip. Put the magnet and a Read more…

If split screwdriver handle, new best done of vinyl plastic or plexiglass. Drill a hole in the plastic, whose diameter is half a millimeter smaller than that of the rod. Then secure the rod in the electric drill Chuck or the drill press and turned on the engine, press in the hole. After the first Read more…

For a uniform bending of the tubing, especially thin-walled, usually filled with sand. But it may happen that at the right moment it will not be on hand. In this case, it is possible to fill the cavity of such a common substance that is literally in every house. Is water. Rather, its hard to Read more…

Even a small picture to decorate her wall, need something to fix. And here a nail is taken, torn Wallpaper, exposed wall, especially in the most modern of them is not so easy to penetrate even a carbide punch. We do easier. Before the next fixation determined where that will be hanging. And in these Read more…