Advice

Hang a hook or bracket to a hollow wall (for example, sheathed with plastic or plywood) is always a problem: fixture does not hold in this place is quickly loosened and popping up. However, such a charge would be reliable, if drilled in a wall of the notched hole to insert one end of thin Read more…

The magazine offered rings from rubber gloves to use for the “tying” of packages. You can use wider rings for sealing the junction of bottle-stopper — is of the Board fluff clay, because he is with the hours that use can get into the contents. Tried to apply the rings of the gas tube, but Read more…

If you want to twist the doubled wire, use the shown ways. Depending on the thickness of the wire, select the appropriate option: for a slim fit and a makeshift reamer with sewing coil or hand vise watchmaker, and for thicker hand drill.

Often in the manufacture of the part to measure the depth of the groove or a blind hole and there is no caliper with depth gauge. In this case, but you can use a conventional ruler and the rod of a ballpoint pen. By setting a ruler on the plane parts and attaching the rod, Read more…

It happens that it is necessary to connect two threaded fasteners fiberglass parts, and also suitable drill nothing. However, this will be enough if you use the following technology. On joined parts is drilled a blind hole and buried the acetone so that it fills the hole, the walls of which exposed to it over Read more…

Sharpen the saw — a simple matter, but it has the potential to injure your fingers on the sharp teeth. Use a cut rubber hose. It is sufficient to cut: it up and push on the part of the saw blade under the restraint of the hand and fingers are intact!   LUBOVSKY O., Gorny, Read more…

When repairing a wooden floor of neshpuntovannye boards there is often a need to replace the entire Board and a portion of it. It is not necessary to tear, especially if it goes under the wall or stationary furniture. Prising in any way repaired, enclose under it a metal rod, he will hold the seat Read more…

The use of floor brush in certain cases uncomfortable. I propose to make a one-handed floor brush from a table, the so-called intelligence — it is used to smetana shavings from the workbench or machine tool. Fasten it to the bracket of thin sheet steel with a bolt and wing nut. Thanks to a brace Read more…

Instead of the usual wooden pegs were the same, but the plastic that slid more than the former and thus hold somewhat worse. To increase their reliability can be invested inside as shown in the drawing, a strip of corrugated rubber or plastic secured under the trailer springs.