Advice

Good to have in the hallway a small chair or Ottoman for pereobuvaniya. If you don’t, I suggest to use this kind of hint. Take any wooden box (even mail order) and simple Refine it: tight or paste any fabric or leatherette. And on the cover before crimping of the stacked soft strip — a Read more…

When painting the ceiling, cornices, etc. paint with a paint brush sometimes drains on hand. This will help avoid simple cropped funnel from a plastic bottle, put on the brush.

If a sheet of glass cut by a few millimeters, then break off the edge you better not side groove of the glass cutter, and pliers. In this strip of glass is often separated from the sheet immediately over the entire length; but even if in parts, the line of cleavage is still neater than Read more…

It is known that in friable material such as drywall or particle Board, the screws holding bad and under load falls. However, it will bind details not worse than a bolt with a nut, if properly prepare the hole for the screw with epoxy. For this purpose the screw is pre-coated with any oily grease Read more…

The photographers know that the development of film in photobucke quicker and more efficiently, if the snail with the film periodically scroll. However, looking out of the reservoir handle of the snail is too short and thin, rotating her uncomfortable. But the standard knob can be increased, pulled her from the champagne cork.

Offer a simple way to protect the blade of the axe with cover from Velocimetry. In a suitable size segment its pre-made punch two holes; the distance between them should be somewhat smaller than the width of the blade. Then from one hole to another with a pair of scissors an incision is made and Read more…

On a circular Pipa can not only dissolve a wooden Board in straight lines, but cut discs of any diameter from sheet material. For this you need only do a simple device-a plywood plate, which is attached to the axis of the future drive. The axle is made of screw, a screw or even a Read more…

Typically, the wood for the stove or fireplace are the arms, which is not always convenient and pleasant. Manufacture on the case of a special tray. Take a sheet of roofing iron, preferably galvanized, of a thickness of 0.5 mm. slightly longer in length your wood, and a width of 300-400 mm. Fold back the Read more…

If it took a long screw thread M2—M6, and they are not (by the way, is not easy to find and sold out), it is easy to produce such a nail of suitable diameter, cut into the rod thread and propilov in the hat slot.   I. GLUKHOV, Saransk, Mordovia