Good recommendations

Often in the manufacture of the part to measure the depth of the groove or a blind hole and there is no caliper with depth gauge. In this case, but you can use a conventional ruler and the rod of a ballpoint pen. By setting a ruler on the plane parts and attaching the rod, Read more…

It happens that it is necessary to connect two threaded fasteners fiberglass parts, and also suitable drill nothing. However, this will be enough if you use the following technology. On joined parts is drilled a blind hole and buried the acetone so that it fills the hole, the walls of which exposed to it over Read more…

Sharpen the saw — a simple matter, but it has the potential to injure your fingers on the sharp teeth. Use a cut rubber hose. It is sufficient to cut: it up and push on the part of the saw blade under the restraint of the hand and fingers are intact!   LUBOVSKY O., Gorny, Read more…

When repairing a wooden floor of neshpuntovannye boards there is often a need to replace the entire Board and a portion of it. It is not necessary to tear, especially if it goes under the wall or stationary furniture. Prising in any way repaired, enclose under it a metal rod, he will hold the seat Read more…

The use of floor brush in certain cases uncomfortable. I propose to make a one-handed floor brush from a table, the so-called intelligence — it is used to smetana shavings from the workbench or machine tool. Fasten it to the bracket of thin sheet steel with a bolt and wing nut. Thanks to a brace Read more…

Instead of the usual wooden pegs were the same, but the plastic that slid more than the former and thus hold somewhat worse. To increase their reliability can be invested inside as shown in the drawing, a strip of corrugated rubber or plastic secured under the trailer springs.

Wheelchair wooden stick, even if it is with a rubber tip in the ice can bring, slipped on the ice surface. However, if the end to drill a hole and insert a sharp metal rod from the cane will be versatile for any season.   V. GOLOVASHIN, Rybnoe, Ryazan region.

Much easier working with a small nails can a upgraded hammer, with magnetic insert (see Fig.). To do this, cut a little wedge-shaped part of the firing pin, drill the socket for insertion in the press or zachekanivajut a small rod from the existing magnet or magnetized steel rod. The technology of them is very Read more…

Elderly person or disabled person to raise the fallen or vyskolznula from the hands of the stick is always a problem. Easier to recover from this situation using a simple “bracelet” (from a leather strap, cord or tape) threaded into the handle hole, as shown in the figure.   V. GOLOVASHIN, Rybnoe, Ryazan region.