Public Design Bureau

The release of carbon dioxide industry miniature engines has caused many young technicians ‘ interest in the models in which you can use this reliable, silent, environmentally friendly motor. In the “M-K” have already talked about a few simple ship models with such engines. Today we offer you to make simple model airplane motor CO2. By construction, this classic high set scheme, made without the use of scarce balsa wood — mostly pine and light lime. The fuselage of the model are collected from pine spars a cross section of 2X2 mm and cross-beams of the same section. The Assembly is the simplest slipway, made of two sheets of plywood, covered with plastic wrap — so that the workpiece is not glued to the slipway. Build order is as follows: the rack-bars fixed with pins, then cut between the frame crossmember and finally the joints fill with epoxy glue so that between the blanks formed a fillet — a fillet transition. Billet spars are pre-bent over a candle flame. First, it makes sense to applied to the wall side of the fuselage, and then collect from half of spatial farm. Please note that the front spars of the fuselage together reinforced frame — lime plate thickness of 3 mm, it also serves as the basis for the engine mounts. The front part of the fuselage top and bottom (bottom to the rear edge of the wing and top to the front) paste over fake veneer thickness of 1 mm.

Everyone is used to what is required for forming the matrix and punch. In many cases, however, can do without the surround matrix — sufficient and shaped holes in sheet metal or plywood. But without the surround of the punch!..

Since 1980, the “geography” of the USSR Championships in the sport of flying remained the same — start small rockets passed on two “spaceports” (“Tapani” under Tbilisi and “Aranci” near Tashkent). But to VIII of the championship was selected the sports airfield “fakhrabad” Dushanbe ask.

Immediately note: we offer avtomodelistov model Cordoba race car, neither in design nor the scheme is not a supernova. All solutions are individually well known, even not too experienced athletes. New design approach for decision models in General.

What can you do — we have no way to get the materials, without which, it seems, is impossible to imagine modern models. A thin fiberglass (not to mention the carbon fabric), the specific binder resins, superdigital and more, thereby yielding better results even in school competitions, this has only dreamed of. And to help these materials in the state, not every corporate enterprise, if at all there is a mug. Well, hope that they eventually can be found in stores at all.

“Competition motors”… These words you will hear today in any event — such was the struggle for victory in almost all sports classes. Ship-, auto – and aircraft modeling — all success is unthinkable without the unique materials and techniques for making homemade or high-powered serial superdigital. The exceptions are rare. Perhaps this is the only copy, yachts and aerobatic Yes “bouzouki”. And the pilots of modern RC UAV-unmanned aerial vehicle-the”acrobats” often complain about the lack of power of the engines!