Public Design Bureau

Those who have not yet acquired a welding machine (SA), I recommend you make it yourself on the basis of a failed induction motor. The cost is minimal, but the result… and development, which can be used for turning scrap stator in a good “svarochnik”, published a lot (see, for example, “modelist-Konstruktor” № 8’92, 11’95, 1’96, 3’96). I would be glad if someone useful to my practice-proven tips.

Mixer when building a house. Cement mortar require a lot, besides he needs occasional stirring. A trough with a shovel is not important here assistants — nama with them before the aching all over my body and the quality of the mixture will remain low. Purchase the same brand design expensive not everyone afford.

Installation for boiling water widespread. Including electrical, type “Titan”. Becoming the owner of one of these decommissioned boilers, decided the best original designs to create electrojuice extractor could not be found. Looked promising case “steel”: perfectly preserved, with tightly screwed-on cover and two interior cylinders.

In the repair and testing of electrical tillers, not equipped with a battery, as well as type motorcycles “Voskhod-ZM” and mopeds have to ensure that the system power supply every time you start the engine. Troublesome, and unnecessary consumption of gasoline. But there is good, in my opinion, the solution is to use as a source of energy for household electricity. Only need the upgraded power unit from child filmoscope.

echnology the manufacture of major components of the mill are quite simple. From thick-walled pipe 60×10 mm should be cut on the machine supporting sleeve and “grab” it to gas or electric to advance cut a circle out of smooth steel sheet with a thickness of about 10 mm. Then, while holding the “oven MITT” in the Chuck of the lathe, the handle to the required size billet cap so that the socket diameter 332 mm coincided with the sizes of available drum. Likewise be made and a second drive.

Getting a series of experiments related to the breeding of cold-resistant varieties of corn, I remembered about the amazing properties of water, treated with a constant electric current. In particular, that formed in the zone of the cathode, the catholyte has reducing (alkaline) properties and behaves according to the truth as “living” water, in contrast to its antipode — anolyte, a kind of oxidizer, or “dead” water produced in the area of the anode.Relying on high biological activity of the catholyte, decided to treat a handful of seeds before sowing in progressiya the ground. “Living” water was required very little. But where is the “spring”, from which it can be obtained?

Read more