It is known that most of the screws ships — lobed, And consequently, when playing them on-models necessary to accurately mark the three holes on the propeller hub, placing their centers is strictly in increments of 120°. Of course, if you need just one screw, this is not too difficult, but a lot of…SOLDERING IRON FOR CIRCUIT BOARDS
Soldering the printed circuit Board by soldering with a recess in the end face of sting, but such a tool is inconvenient to solder the wires and radio with a conventional outboard mounting. If the hole to be drilled not with the butt, but sting side (see picture), this versatile soldering iron can perform any Read more…




There are restless people, they are literally turning on the seats, even when doing serious work. Why not meet them and not make the chair so that he could turn?


Strong, with well-developed brush hand can easily cope with the physical work, and with a hockey stick, tennis racket, paddle.

For cooling microelectrodes rotating propeller for flying model aircraft, usually set just before small anchor impeller. It blows air through the casing of the motor. The most intensively blown by the front part of the winding and a set of anchors.
